[microsound] Re:[microsound] Sound file switching using zerox~

[Tobias Reber <tobiasreber@xxxxxxxxxxx>]

Matrix~ did the job. I'd only used in binary so far. Thanks a lot for the
hint!

Tobias


Am 19.5.2006 15:22 Uhr schrieb "mattyo" unter <m@xxxxxxxxxxxxxx>:

> Look at the matrix~ object.  You can set a ramptime between settings
> in miliseconds with the "ramp" message.
> 
> \M
> 
> 
> 
> On May 19, 2006, at 8:06, Tobias Reber wrote:
> 
>> 
>> Hi group!
>> 
>> I've been lurking here for  while and followed the discussions with
>> interest. But I'm afraid my first post to this group is a rather
>> max-ish
>> technical question:
>> 
>> I'd like to be able to switch very rapidly between two sound files
>> using the
>> zero crossings of a signal. Now, the first idea was to just put a
>> zerox~
>> object after a cycle~, but that of course causes much clicking.
>> 
>> Any tips on how I can solve that? How, for example, would I be able to
>> interpolate between the files?
>> 
>> Thanks for any input,
>> 
>> Tobias
>> 
>> 
>> 
>> ---------------------------------------------------------------------
>> To unsubscribe, e-mail: microsound-unsubscribe@xxxxxxxxxxxxx
>> For additional commands, e-mail: microsound-help@xxxxxxxxxxxxx
>> website: http://www.microsound.org
>> 
>> 
>> 
> 
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: microsound-unsubscribe@xxxxxxxxxxxxx
> For additional commands, e-mail: microsound-help@xxxxxxxxxxxxx
> website: http://www.microsound.org
> 



---------------------------------------------------------------------
To unsubscribe, e-mail: microsound-unsubscribe@xxxxxxxxxxxxx
For additional commands, e-mail: microsound-help@xxxxxxxxxxxxx
website: http://www.microsound.org